<util/twi.h>: TWI bit mask definitions

---

Detailed Description

 #include <util/twi.h> 

This header file contains bit mask definitions for use with the AVR TWI interface.

TWSR values
Mnemonics: TW_MT_xxx - master transmitter TW_MR_xxx - master receiver TW_ST_xxx - slave transmitter TW_SR_xxx - slave receiver
#define	TW_START   0x08
#define	TW_REP_START   0x10
#define	TW_MT_SLA_ACK   0x18
#define	TW_MT_SLA_NACK   0x20
#define	TW_MT_DATA_ACK   0x28
#define	TW_MT_DATA_NACK   0x30
#define	TW_MT_ARB_LOST   0x38
#define	TW_MR_ARB_LOST   0x38
#define	TW_MR_SLA_ACK   0x40
#define	TW_MR_SLA_NACK   0x48
#define	TW_MR_DATA_ACK   0x50
#define	TW_MR_DATA_NACK   0x58
#define	TW_ST_SLA_ACK   0xA8
#define	TW_ST_ARB_LOST_SLA_ACK   0xB0
#define	TW_ST_DATA_ACK   0xB8
#define	TW_ST_DATA_NACK   0xC0
#define	TW_ST_LAST_DATA   0xC8
#define	TW_SR_SLA_ACK   0x60
#define	TW_SR_ARB_LOST_SLA_ACK   0x68
#define	TW_SR_GCALL_ACK   0x70
#define	TW_SR_ARB_LOST_GCALL_ACK   0x78
#define	TW_SR_DATA_ACK   0x80
#define	TW_SR_DATA_NACK   0x88
#define	TW_SR_GCALL_DATA_ACK   0x90
#define	TW_SR_GCALL_DATA_NACK   0x98
#define	TW_SR_STOP   0xA0
#define	TW_NO_INFO   0xF8
#define	TW_BUS_ERROR   0x00
#define	TW_STATUS_MASK
#define	TW_STATUS   (TWSR & TW_STATUS_MASK)
R/~W bit in SLA+R/W address field.
#define	TW_READ   1
#define	TW_WRITE   0

---

Define Documentation

#define TW_BUS_ERROR   0x00

illegal start or stop condition

#define TW_MR_ARB_LOST   0x38

arbitration lost in SLA+R or NACK

#define TW_MR_DATA_ACK   0x50

data received, ACK returned

#define TW_MR_DATA_NACK   0x58

data received, NACK returned

#define TW_MR_SLA_ACK   0x40

SLA+R transmitted, ACK received

#define TW_MR_SLA_NACK   0x48

SLA+R transmitted, NACK received

#define TW_MT_ARB_LOST   0x38

arbitration lost in SLA+W or data

#define TW_MT_DATA_ACK   0x28

data transmitted, ACK received

#define TW_MT_DATA_NACK   0x30

data transmitted, NACK received

#define TW_MT_SLA_ACK   0x18

SLA+W transmitted, ACK received

#define TW_MT_SLA_NACK   0x20

SLA+W transmitted, NACK received

#define TW_NO_INFO   0xF8

no state information available

#define TW_READ   1

SLA+R address

#define TW_REP_START   0x10

repeated start condition transmitted

#define TW_SR_ARB_LOST_GCALL_ACK   0x78

arbitration lost in SLA+RW, general call received, ACK returned

#define TW_SR_ARB_LOST_SLA_ACK   0x68

arbitration lost in SLA+RW, SLA+W received, ACK returned

#define TW_SR_DATA_ACK   0x80

data received, ACK returned

#define TW_SR_DATA_NACK   0x88

data received, NACK returned

#define TW_SR_GCALL_ACK   0x70

general call received, ACK returned

#define TW_SR_GCALL_DATA_ACK   0x90

general call data received, ACK returned

#define TW_SR_GCALL_DATA_NACK   0x98

general call data received, NACK returned

#define TW_SR_SLA_ACK   0x60

SLA+W received, ACK returned

#define TW_SR_STOP   0xA0

stop or repeated start condition received while selected

#define TW_ST_ARB_LOST_SLA_ACK   0xB0

arbitration lost in SLA+RW, SLA+R received, ACK returned

#define TW_ST_DATA_ACK   0xB8

data transmitted, ACK received

#define TW_ST_DATA_NACK   0xC0

data transmitted, NACK received

#define TW_ST_LAST_DATA   0xC8

last data byte transmitted, ACK received

#define TW_ST_SLA_ACK   0xA8

SLA+R received, ACK returned

#define TW_START   0x08

start condition transmitted

#define TW_STATUS   (TWSR & TW_STATUS_MASK)

TWSR, masked by TW_STATUS_MASK

#define TW_STATUS_MASK

Value:

(_BV(TWS7)|_BV(TWS6)|_BV(TWS5)|_BV(TWS4)|\
                                _BV(TWS3))

The lower 3 bits of TWSR are reserved on the ATmega163. The 2 LSB carry the prescaler bits on the newer ATmegas.

#define TW_WRITE   0

SLA+W address